GRAY OXIDE PRIMER
Gray Oxide Primer is very chemical resistant with special rust inhibitors, and a perfect coating for a corrosive environment.
This product can be applied up to 30 MIL’s and is perfect for filling in dents, holes, or large imperfections. You can spray on ambient via electrostatic or simply use heat to build up the Gray Oxide Primer. You can pre-heat your part in an oven, use a heat gun, a torch, or any other heat source on your substrate to get your primer build up if needed. After you fill in your imperfections, sand the primer to a smooth finish and you are now ready to apply your topcoat.
Gray Oxide Primer also helps stop outgassing, by pre-heating your part/substrate to a temperature between 300 – 500F, you can apply this primer on hot to get a heavy build up, to entrap the outgassing. This product’s gel time is quick, and depending on the substrate you might not need to put the part back in the oven before applying your topcoat, most of the time it’s gelled out enough to go ahead and apply your topcoat, then fully cure to crosslink your coatings together.
BONDED EPOXY
FULL CURE SCHEDULE 462F/1 MIN
or 438F/2 MIN
or 400F/5 MIN
or 375F/10 MIN @ PMT (PART METAL TEMPERATURE)
SPECIFIC GRAVITY = 1.44
THEORETICAL COVERAGE = 134SQ. FT./LB/MIL.
IMPACT RESISTANCE = @ 25°C (77°F) 160 IN.LBS.
RECOMMENDED FILM THICKNESS = ANYWHERE FROM 3-14 MILS. (CAN APPLY UP TO 30 MILS.)
