MICRO SLICK PISTON COATING

Same Day Shipping on orders placed before 1:00 PM EST via UPS & FedEx. Daily order volume may delay Flat Rate Shipping orders until the next business day. Orders are not processed or shipped during weekends and holidays.


MICRO SLICK PISTON COATING
Click to enlarge
Price: $55.49 (lb.) each
Product ID : MICRO SLICK

Purchase


Description

 MICRO SLICK AIR DRY CERAMICS (8 Ounces) 

Description: Micro Slick is a ceramic dry film coating used to reduce friction on a variety of internal engine coponents, such as piston skirts, cam lobes, valve stems, lifters and an other surfaces requiring a high temperature coating with a low coefficient of friction.  

1 PINT COVERS ROUGHLY 50 SQUARE FEET, IT TAKES ABOUT 4 OUNCES TO DO A SET OF SHORTY HEADERS, AND ABOUT 8-12 OUNCES TO DO A SET OF LONG HEADERS!

* THIS ITEM CAN ONLY SHIP UPS OR FEDEX GROUND.

CURE SCHEDULE:
TACK FREE AT 40 MINUTES
DRY AFTER 24 HOURS
FULLY CURED AFTER 5 DAYS
CAN WITHSTAND TEMPERATURES UP TO 2,000F+

SURFACE PREPARATION: All parts must be absolutely free of all oils, grease, moisture, dust, scale or corrosion.

METALS: For steel, sandblast with 80-100 grit aluminum oxide or similar. Softer metals, such as aluminum, use 100-120 grit aluminum oxide or similar at 35-40 PSI using a suction type blaster.

 *NOTE: Phosphating may be preformed in lieu of sandblasting or in conjunction with the above mechanical etch.

FINAL CLEAN: Before spraying the part must be thoroughly cleaned using air blast, hot water rinse, solvent base rinse, or any other method that provides a clean dry surface. DO NOT USE petroleum based solvents,

MIXING: Stir and shake well, it is best to mix in a food blender type mixer or any unit capable of producing high speed shear/dispersion. 

*NOTE: Use of non-distilled water may adversely affect product performance and void products warranty, whether express or implied.

PRIMER: No primer needed.

APPLICATION TEMPERATURES:

                             Material   Surfaces   Amblent   Humidity

Normal               18-30ºC    18-30ºC    16-32ºC    65-85%

Minimum           13ºC          13ºC          10ºC          50%

Maximum         35ºC          38ºC          38ºC          95%                                

SPRAY: Apply coating in light fog passes (approximately 20% overlap) to achieve a thickness of .001” to .0015”. Use sufficient air volume for correct operation of equipment. (Minimum 50 PSI) Minimum part temperature should be 65f, if below warm up part. Spray at a right angle to part with a 1mm or smaller nozzle size. Spray all irregular surfaces and edges first, making an extra pass later. Check part for complete coverage.

SPRAY GUN & Mfr.: Any conventional unit. Recommended gravity feed type touch-up gun. (Important that nozzle size be 1mm or less) YOU ARE BEST TO USE A CHEAP HARBOR FREIGHT GUN, AND THROW IT AWAY WHEN DONE, AS THE CERAMICS EAT AWAY AT THE PARTS!

Product Reviews

Login or Register to write the first review.